Hitachi Compute Blade 500 Series - Page 82

Item Description
Boot Device
List
A target LU list for priority settings
Registers a list of target LUs to be searched for use when the boot
priority is set to Enable. Search is performed to detect one only among
LUs registered in the list. Even if no registered LU is detected, currently
available LUs will not be searched.
Starting Priority number is different according to the management
module firmware version.
Firmware version A0120 or earlier: Starting number is 0.
(Priority 0 to 7)
Firmware version A0125 or later: Starting number is 1.
(Priority 1 to 8)
LPAR manager tab
[Management module firmware version A0240 or later]
Table 2-70 LPAR manager tab Items
Item Description
Server Blade
status
Power Displays the power status of the server blade.
LP condition
Condition
1
Displays the LPAR Manager operation status.
Normal: Running normally.
Starting LPAR feature: LPAR Manager is
starting.
Error: An error occurred.
2-72
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide