11 | 106
2. Warranty.
1. All equipment shall have warranty coverage by the supplier against manufacturing or assembly faults conducted by the
supplier, for the period of 12 months, counting from the issuing of the sales invoice. The period is irrevocable except in cases of
extended warranty previously noted in contract.
2. During warranty time, the supplier will repair, with no additional charge, the faulty products, providing adjustments, replacing
or re-manufacturing, of all the equipment or its modules and components that present unusual behavior;
2.1. The repaired/replaced products are covered for an additional period of 3 (three) months or up to the end of the original
warranty time, taking into count the longer period;
2.2. If the additional 3 (three) months term, referred above, is higher than the original warranty term, the warranty will only
extend to the repaired/replaced modules or
components;
2.3. The warranty will become effective in the supplier’s factory; therefore, it is not a responsibility of the supplier: the
shipment of any modules, components or any other equipment or accessory. These expenses will be, when due,
a responsibility of the Purchaser.
2.4. The Purchaser may choose a visit of the supplier’s technical personnel, instead of submitting the goods for
factory repair, although the expenses relative to transportation, lodge and nourishment of the supplier’s technicians will occur
at sole expense of the Purchaser, upon budget approval.
3. The supplier is relieved of the warranty terms in the hereinafter situations:
3.1. Faults or defects caused by AC Mains variation, atmospheric phenomena or accidental;
3.2. Faults or defects caused by inadequate installation of the goods, not complying with the OPERATING MANUAL(S) or by
negligence of the minimum infrastructure requirements in the installation site, which is referred in the ANNEX 1 herein
attached.
3.3. Faults or defects caused by inadequate usage of the products, not complying with the OPERATING MANUAL(S) or
by lack of proper preventive maintenance recommended in the product’s manual.
3.4. In event of the goods and its accessories are submitted to 3rd Party maintenance, unauthorized by the supplier, as
well as removal or violation of its serial number.
4. The supplier shall employ, during warranty term, original parts and components listed by the product’s manufacturer.
5. The technical assistance must be held by the SUPPLIER or its accredited personnel or companies, failing which will result
in warranty voidance.
1. This equipment has been tested and found to comply with the limits for a Class A Digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case
the user will be required to correct the interference at his own expense. The antenna(s) used for
this transmitter must be fixed-mounted on the outdoor permanent structures. RF exposure compliance is addressed
at the time of licensing, as required by the responsible FCC Bureau(s), including antenna co-location requirements of
§1.1307(b)(3).
2. Changes or modifications not expressly approved by Hitachi Kokusai Electric Comark LLC could void the user's authority
to operate the equipment.
3. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
2.1 FCC Compliance
To Next Page
Loading...