91 | 106
3.2. Startup
The equipment management interface is subdivided into six (6) tabs as shown below:
⇨ Alarms – Verification of existing alarms (System Alarms).
⇨ Setup – Power Setup, import and export files.
⇨ Measurements – Verification of system measures.
⇨ Power – Check the power supply voltage measurements, current and module temperature
amplifier.
⇨ Remote – Change system settings (IP Address/ Netmask/ Gateway).
⇨ User – Change / configure password (Current Password/ New Password/ Confirm New Password).
3.3. Alarms
Through Alarms interface, it is possible to monitor alarms detected in the transmitter. If there are alarms
the Alarms tab will flashing in red to access another tab.
3.3.1. Alarms
Shows the alarms that are occurring
To Next Page
Loading...