Hitachi E-Compact Medium Power Series - Ethernet Connections; Internal Ground Connections

81 | 106
E-Compact Medium Power
4.2. Ethernet Connections
Connect between the switch module and Telesupervision Module, Exciter 1, Exciter
2, Control Module 1, Control Module 2.
Use Cat5 Cable whit RJ45 Connector.
1. Connection between the switch module and CONTROL PORT connector of the
transmitter top panel.
2. Connection between the switch module and the front Ethernet port of the
CM8001 Controller A.
3. Connection between the switch module and the front Ethernet port of the
CM8001 Controller B.
4.3. Internal Ground Connections
Connect the grounding mesh in the GND screw on the rear panel of each control module.
SCREW
GROUNDING
SCREW
GROUNDIN
G
Connections
Connections
01
Main Exciter (Not Included)
02
Backup Exciter (Not Included)
03
Switch Module
04
Main Control Module Drawer – MOD GV
40056
05
Backup Control Module Drawer – MOD
GV 40056 (Optional)
01
02
03
04
05