Hitachi E-Compact Medium Power Series - Main Menu ⇨ Measurements

35 | 106
E-Compact Medium Power
#
Parameter
Position
#
Description / Functionality
1/9
Power Setup
1100
1/1
Changes the output power of the Equipment.
2/9
Transmitter Setup
1200
1/2
Automatic Level Control: On/Off
2/2
Ctr Mode: Active / Standby
3/9
Time and Date Setup
1300
1/1
Change the date, time and date format (dd/mm/yy or
mm/dd/yy)
4/9
Password Setup
1400
1/2
Enable / Choose new password
2/2
Disable Password
5/9
Alarms Mask
1500
1/1
Reflected Power – Set de Alarm Mask for Reflected Power
6/9
USB Host Access
1600
1/1
System Upgrade – Used to system upgrade via USB card.
7/9
Transistor Bias
Adjustment
1700
1/4
LDMOS Drain Voltage - The values are pre-set at the factory.
2/4
Carrier Amp. Current - The values are pre-set at the factory.
3/4
Peak Amp. Gate Voltage - The values are pre-set at the
factory.
4/4
Status: show the status exciter: (Active / Standby)
8/9
PA Temperature
Control
1800
1/1
Allows to set the operating temperature of the Powers
Amplifiers.
9/9
Control Mode
1900
1/1
Enable control module acess remote
[2000] - Main Menu ⇨ Measurements
[0000]
Main Menu
[1000]
Setup Menu
[2000]
Measurements
[3000]
System Alarms/
Log
[4000]
Remote Acces
The "Measurements" menu allows access to read the operating parameters of the equipment (read
only).
#
Parameter
Position
#
Description / Functionality
1/7
Power
2100
1/3
Programmed: Show the Programmed power measurement.
2/3
Forward: Show the value of Forward Output Power (Watts).
Reflected: Show the value of Reflected Output Power (Watts).
3/3
ALC Reference Voltage: Show the value (Volts).
2/7
Exciter Status
-
-
Active / Fail
3/7
Drawers
2300
1/3
Drawers Measurements