Hitachi E-Compact Medium Power Series - Changing AC Mains

66 | 106
E-Compact Medium Power
6.5.4. Changing AC Mains
Once the mains power is set at the factory, there is the possibility to change its input type feature for the
following cases:
For Not Available cases, it is necessary to replace the complete AC Mains Module
for the compatible electrical grid. Contact Hitachi Kokusai Linear Service.
When replacing the AC Mains type, pay attention to circuit breakers, varistors and
sparklers models for their characteristics. Each type of AC Mains uses different
values of these protection components.
Using these protection components outside the features described in this manual
may cause damage to the equipment.
AC Main Factory Set
Setup Change Possibility
M208
B240
T208 / T240
T380
M208
Factory Set
USE B220 Setup
See 6.5.3
Not Available
Not Available
B240
USE M220 Setup
See 6.5.2
Factory Set
Not Available
Not Available