Hitachi E-Compact Medium Power Series - Main Menu ⇨ System Alarms;Log

38 | 106
E-Compact Medium Power
#
Parameter
Position
#
Description / Functionality
4/7
Control Module
Power Supply
2400
1/2
+3,3V : OK - Check de +3,3Vcc Ctrl Module Power Supply
+15V : OK - Check de +15Vcc Ctrl Module Power Supply
2/2
+5V : OK - Check de +5Vcc Ctrl Module Power Supply
+28V : OK - Check de +28Vcc Ctrl Module Power Supply
5/7
Communication
Status
2500
1/3
Drawers Communication Status (OK / Fail / -- “not present”)
P01 / P02 / P03 / P04 – Power Drawer 1 / 2 / 3 / 4
2/3
Drawers Communication Status (OK / Fail / -- “not present”)
P05 / P06 / P07 / P08 – Power Drawer 5 / 6 / 7 / 8
3/3
Control Module Communication Status
(OK / Fail / -- “not present”)
6/7
Software/Hardware
Version
2600
1/4
Control: Control Module Version
2/4
Drawers Version. (◀ or ▶) Selects the Power Drawer
3/4
Digi: Ethernet Module Version
4/4
CIP Version / CIM Version
7/7
Eqp. Power Supply
2700
1/1
Eqp. Power Supply Measurements (OK / Fail)
15V / 8V 50V
[3000] - Main Menu ⇨ System Alarms/Log
[0000]
Main Menu
[1000]
Setup Menu
[2000]
Measurements
[3000]
System
Alarms/Log
[4000]
Remote Acces
This menu provides information on current and past alarms for preventive/corrective maintenance
purposes.
Before detailing access to the Sub-menus of this item, it is important to know what the alarms are and
their possible solutions..
There are two alarm lists; "Equipment Alarms", which refers to faults in the equipment as a whole and
"Drawers Alarms", which refers to faults in power amplifier drawers and thus impact the transmitter’s
operation reflected in the operation of the equipment.