Hitachi RAS-(4-6)HVRNS2E - Suspended Unit

2 Unit Installation
24
SMGB0064 rev.0 - 08/2011

Suspended unit
1 Suspend the unit as shown in the gures.
2 Ensure that wall can withstand the weight of the outdoor unit indicated on the specications plate.
3 It is advisable that each foot support should bear the full weight of the unit (in order take account of applied stress
fatigue when unit is operating).
RAS-3HVRNM2E RAS-(4-6)H(V)RNM2E
RAS-(4-6)H(V)RNS2E RAS-(8-12)HRNM
RAS-(8/10)HRNSE
1
2
3
1
2
3
1. Wall support
2. Anchor bolts
3. Supplied by the installer
C A U T I O N
• Follow these installation procedures carefully
- The installation must be done so as to ensure that the outdoor unit does not lean vibrate make a noise or
fall in the event of strong gusts of wind or earthquakes. Calculate the resistance to vibration (caused by
earthquakes) to guarantee that the installation is sturdy enough to prevent falls. Secure the unit with cables
(eld-supplied) when installing the unit in a place without walls or wind protection and where it is likely to
be exposed to gusts of wind.
- When using the vibration-proof rubber mat secure it at four points on the front and back.