10 Servicing
413
SMGB0064 rev.0 - 08/2011
10
Removing the compressor
1 Remove the service cover upper cover bottom service cover and rear cover following Removing service cover, see on
page 408 Removing upper cover, see on page 409 and Removing bottom service cover and rear cover, see on page 410. When
the outdoor unit is installed close to a wall remove the refrigerant piping and move the unit from the wall.
2 Remove the electrical box following Removing electrical box, see on page 412.
3 Collect the refrigerant from the check joint.
4 Remove the valve stay.
1. Upper cover.
2. Rear panel.
3. Check joint.
4. Rear pipe cover.
5. Crankcase heater.
5 Open the soundproof cover wrapped around the compressor
and remove the terminal box cover of the compressor body.
Disconnect the compressor wires in the terminal box and re-
move the thermistor on top of the compressor. Remove the
soundproof cover.
• Check the terminal codes and mark bands when disconnecting
the wires. Connecting wires in wrong order at reassembling
may result in compressor damage.
6 Remove the rubber cap and the thermistor attached on top of
the compressor.
7 Remove the crankcase heater.
1
2
3
4
5
6
N O T E
• Compressor piping must be connected by brazing. MAKE SURE that any ammable material is not around
before heating with burner for the oil inside the piping may ame up.
• Do not expose the refrigerant cycle to the atmosphere for a long period to avoid moisture or dust into the
cycle. Be sure to replace the compressor immediately after removing. Seal the suction and discharge pi-
pes when the refrigerant cycle is left unattached for a long period.
• Remove the cap of new compressor right before the replacement. Before mounting the compressor seal
the suction and discharge pipes with a tape to protect the compressor from dust. Remove the tape when
blazing the pipe.
• For piping at reassembling ensure that the compressor terminal numbers and wiring mark band codes are
matched. Incorrect wiring numbers may result in inverse rotation and damage of the compressor.
1. Soundproof cover.
2. Oil heater.
3. Cut part.
A. Direction to remove the cover.
3
2
1
To Next Page
Loading...