Hitachi RX - Page 134

●Long-term Shutdown 6-29
Circulation control
Select option; press [Start/Cont.] Proc. status:
2015.07.0712:45
Com=0
[Stop ]
Eject ink
(Goes to Standby)
Cleaning stop No-cleaning stop
Nozzle backwash
Recovery-line
cleaning
Ink replacement
Ink filter
replacement
Ink circulation
Cancel
Makeup refill for
air removal
Start/Continue
HOME
Prev.Dsp.
NextDsp.
Process prior to
long-term shutdown
Process after
long-term shutdown
Makeup refill
2015.07.0712:45
Com=0
InkDrainage
Systemclean
InkDrainage
Systemclean
InkDrainage
Systemclean
Process : Process prior to
long-term shutdown
Always pay attention to the following before operation.
・Depending on the ink types, storage temperature or storage
term the clogging formed by residual ink the circula-
tion system may occur even if this process is performed.
・For the storing method, it is recommended contact your
local distributor.
Operation guide
Proc. status:
Circulation control [Stop ]
Start/Continue
Abort
Open the "Circulation control" screen, and press the
Process prior to long-term shutdown key and the Start/Continue key.
5
The following guidance appears. Confirm the message and Press
Start/Continue key.
6
Start/Continue
Follow the operation guidance on the screen and drain the ink from the ink
filter and ink circulation system.
● Press Abort to cancel ink draining.
● When Abort is selected, go back to step 5 above and continue.
7
If ink is accidentally spilt, wipe it up
promptly with wiping paper or
equivalent.
In addition, do not close the
maintenance cover until you are
sure that the wiped area is
completely dried.
CAUTION
Start/Continue
Recovery block