18
PMEN0654 rev.0 - 12/2023
5
GENERALINSTRUCTIONSONTHEINSTALLATIONOFREFRIGERANTPIPES
REFRIGERANT PIPING AND REFRIGERANT CHARGE
• Use nitrogen gas for blowing during pipe brazing work. Otherwise a lot of oxidaon lm will
occur inside of tubes. This lm will be ecked o aer operaon and will circulate in the cycle,
resulng in clogged expansion valves, bad inuence to the compressor, etc.
• Cap the end of the pipe when pipe is to be inserted through a hole or while other installaon
work is being carried out, do not put pipes on the ground directly without a cap or vinyl tape at
the end of the pipe.
• If piping installaon is not completed unl next day or over a longer period of me, braze o the
ends of the piping and charge with oxygen free nitrogen through a Schrader valve type access
ng to prevent moisture and parcle contaminaon.
In case of geng the pipe through a hole in the wall:
In Case of Getting the Pipe
Through a Hole in the Wall
Correct
CorrectIncorrect Incorrect
Correct Incorrect
HoleHole
Attach a cap or put a plastic bag
over the pipe end.
Attach a cap or put a plastic
bag over the pipe end.
Attach a cap or put a plastic
bag over the pipe end.
Rubber Band
Do not place the pipe
directly on the ground.
Rain water
can come in.
In Case of Rain
Correct Incorrect
Hole
Hole
Cap or plasc bag
Do not place the pipe directly on the ground:
In Case of Getting the Pipe
Through a Hole in the Wall
Correct
CorrectIncorrect Incorrect
Correct Incorrect
HoleHole
Attach a cap or put a plastic bag
over the pipe end.
Attach a cap or put a plastic
bag over the pipe end.
Attach a cap or put a plastic
bag over the pipe end.
Rubber Band
Do not place the pipe
directly on the ground.
Rain water
can come in.
In Case of Rain
Correct
Incorrect
Cap or plasc bag
In Case of Getting the Pipe
Through a Hole in the Wall
Correct
CorrectIncorrect Incorrect
Correct Incorrect
HoleHole
Attach a cap or put a plastic bag
over the pipe end.
Attach a cap or put a plastic
bag over the pipe end.
Attach a cap or put a plastic
bag over the pipe end.
Rubber Band
Do not place the pipe
directly on the ground.
Rain water
can come in.
Correct
Incorrect
Rain water can
come in
Rubber band
Cap or plasc bag
Where the copper pipe is supplied in rolls, t a cap on the end and unwind it while it is resng on
the ground so that the turning movement of the roll as it is unwound forms a straight pipe.
NOTE
• The rolls of copper refrigeraon pipe are normally supplied with caps on their ends.
• Where the roll of pipe does not come supplied with caps, check that the inside of the pipe is
clean. If it is not, use a new roll of pipe.
• It is also possible to cover the end of the pipe temporarily using high quality adhesive tape.
• Do not wind and unwind the pipe connuously, as the properes of the copper for refrigeraon
pipes are altered, making it more rigid and brile.