Hitachi WL200 Series - 6.3 Operation with frequency command [Hz]

19
[Setting example]
After power ON, changing from . display to change the  (Run command source)
data.
Function code xxx are for monitor and not possible to change.
Function codes xxx other than  are reflected on the performance just after changing the data
(before pressing SET key), and there will be no blinking.



Display is solid lighting.



.
 Data of  will be shown on the
display after the first power ON
 Press [ESC] key to show
the function code
 Press [ESC] key to move
on to the function group 
 Press [ESC] key Once to move
on to the function group .
 Press Up key to change increase
function code (  )
 Press SET key to display the data of 
 Press SET key to set
and save the data
When data is changed, the display
starts blinking, which means that new
data has not been activated yet.
ESC


SET
ESC
ESC
SET
ESC


:Fixes and stores the data and moves back to the function code
:Cancels the change and moves back to the function code
SET
ESC
SET
 Press up key to increase the
data (  )