Hitachi WL200 Series - 10.2 Appearance and Dimensions

67
“C” Function
A
B
Defaults
Func.
Code
Name
Description
Initial
data
Units

[AM] terminal selection
(Analog voltage output
0...10V)
9 programmable functions:
Output frequency
Output current
Output voltage
Input power
Electronic thermal load ratio
LAD frequency
Heat sink temperature
General output
Option


07
[LAD]


Digital current monitor
reference value
Current with digital current monitor output
at 1,440Hz
Range is 20 % to 150 % of rated current


Rated
current
A

Output [11] active state
Select logic conversion, two option codes:
normally open [NO]
normally closed [NC]


00


Output [12] active state


00
-

Alarm relay active state


01


Output mode of low current
detection
Two option codes:
During acceleration, deceleration and
constant speed
During constant speed only


01


Low current detection level
Set the level of low load detection, range
is 0.0 to 1.5 * inverter rated current


Rated
current
A

Output mode of overload
warning
Two option codes:
During accel., decel. and constant
speed
During constant speed only


01


Overload warning level
Sets the overload warning signal level
between 0% and 200% (from 0 to two time
the rated current of the inverter)


Rated
current
x 1.15
A

Overload warning level,
2
nd
motor


Rated
current
x 1.15
A

Frequency arrival setting
for acceleration
Sets the frequency arrival setting
threshold for the output frequency during
acceleration,
range is 0.0 to 400.0 Hz


0.0
Hz

Frequency arrival setting
for deceleration
Sets the frequency arrival setting
threshold for the output frequency during
deceleration,
range is 0.0 to 400.0 Hz


0.0
Hz

PID deviation level
Sets the allowable PID loop error
magnitude (absolute value), SP-PV, range
is 0.0 to 100 %


3.0
%

Frequency arrival setting 2
for acceleration
Set range is 0.0 to 400.0 Hz


0.00
Hz

Frequency arrival setting 2
for deceleration
Set range is 0.0 to 400.0 Hz


0.00
Hz

PID FBV output
high limit
When the PV exceeds this value, the PID
loop turns OFF the PID second stage
output, range is 0.0 to 100 %


100.0
%

PID FBV output
low limit
When the PV goes below this value, the
PID loop turns ON the PID second stage
output, range is 0.0 to 100 %


0.0
%