Hitachi WL200 Series - Appendix object list; Monitor mode: group d

68
“C” Function
A
B
Defaults
Func.
Code
Name
Description
Initial
data
Units

Electronic thermal warning
level
Set range is 0 to 100%
Setting 0 means disabled.


90.
%

Zero speed detection level
Set range is 0.00 to 100.0Hz


0.00
Hz

Heat sink overheat warning
Set range is 0. to 110. C


100.
C

Communication speed
Eight option codes:
2,400 bps
4,800 bps
9,600 bps
19,200 bps
38,400 bps
57,600 bps
76,800 bps
115,200 bps


05
baud

Modbus address
Set the address of the inverter on the
network. Range is 1 to 247


1


Communication parity
Three option codes:
No parity
Even parity
Odd parity


00


Communication stop bit
Two option codes:
1 bit
2 bit


1
bit

Communication error select
Selects inverter response to
communications error.
Five options:
Trip
Decelerate to a stop and trip
Disable
Free run stop (coasting)
Decelerates to a stop


02


Communication error
time-out
Sets the communications watchdog timer
period.
Range is 0.00 to 99.99 sec
0.0 = disabled


0.00
s

Communication wait time
Time the inverter waits after receiving a
message before it transmits.
Range is 0. to 1000. ms


0.
ms

O input span calibration
Scale factor between the external
frequency command on terminals L–O
(voltage input) and the frequency output,
range is 0.0 to 200.0%


100.0
%

OI input span calibration
Scale factor between the external
frequency command on terminals L–OI
(voltage input) and the frequency output,
range is 0.0 to 200.0%


100.0
%

Thermistor input (PTC)
span calibration
Scale factor of PTC input.
Range is 0.0 to 200.0%


100.0
%

Debug mode enable
Displays debug parameters.
Two option codes:
Disable
Enable <Do not set>
(for factory use)


00


Communication selection
Modbus-RTU
 EzCOM
 EzCOM<administrator>


00
