4
NEVER LEAVE THE CHARGER UNATTENDED WHILE IT IS CONNECTED TO ITS POWER
SOURCE. IF ANY MALFUNCTION IS FOUND, TERMINATE THE PROCESS AT ONCE AND
REFER TO THE OPERATION MANUAL.
A The allowable AC input voltage is 100-240V AC.
A Keep the charger away from dust, damp, rain, heat, direct sunlight and excessive vibration.
A If the charger is dropped or su ers any type of impact, it should be inspected by an
authorized service station before using it again.
A This charger and the battery should be put on a heat-resistant, non- ammable and non-
conductive surface.
A Never place a charger on a car seat, carpet or similar surface. Keep all ammable, volatile
materials away from the operating area.
A Make sure you know the speci cations of the battery to be charged to ensure it meets the
requirements of this charger. If the program is set up incorrectly, the battery and charger
can be damaged.
A Fire or explosion can occur due to overcharging.
A To avoid a short circuit between the charge lead, always connect any charge adapters to the
charger rst, then connect the battery. Reverse the sequence when disconnecting.
A Never attempt to charge the following types of batteries:
• A battery tted with an integral charge circuit or a protection circuit
• A battery pack which consists of di erent types of cells (including di erent manufacturer’s
cells)
• A battery that is already fully charged or just slightly discharged and non-rechargeable
batteries (these pose an explosion hazard)
• A faulty or damaged battery
• Batteries installed in a device or which are electrically linked to other components
• Batteries that are not expressly stated by the manufacturer to be suitable for the currents
the charger delivers during the charge process
Warning and Safety Notes
Warning
To Next Page
