Hitron CGN - Logging into the CGN

INTRODUCTION
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
22
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
22
HITRON CGN USER’S GUIDE
5
You can get an IP address automatically, or specify one manually:
If your CGN’s DHCP server is active, select Get an IP address
automatically.
If your CGN’s DHCP server is active, select Use the following IP address.
In the IP address field, enter a value between 192.168.0.2 and
192.168.0.254 (default). In the Subnet mask field, enter 255.255.255.0
(default).
NOTE: If your CGN is not using the default IP address, enter an IP address and
subnet mask that places your computer in the same subnet as the CGN.
6 Click OK. The Internet Protocol (TCP/IP) window closes. In the Local Area
Connection Properties window, click OK.
Your computer now obtains an IP address from the CGN, or uses the IP address that
you specified, and can communicate with the CGN.
1.5 LOGGING INTO THE CGN
Take the following steps to log into the CGN’s GUI.
NOTE: You can log into the CGN’s GUI via the wireless interface. However, it is
strongly recommended that you configure the CGN via a wired connection on
the LAN.
1 Open a browser window.
2 Enter the CGN’s IP address (default 192.168.0.1) in the URL bar. The Login
screen displays.