Hitron CGN - Page 25

INTRODUCTION
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
25
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
25
HITRON CGN USER’S GUIDE
There are two ways to reset the CGN:
Press the RESET button on the CGN, and hold it in for ten seconds or longer.
Click WAN/LAN > Backup. In the screen that displays, click the Factory Reset
button.
The CGN turns off and on again, using its factory default settings.
NOTE: Depending on your CGN’s previous configuration, you may need to re-
configure your computer’s IP settings; see IP Address Setup on page 20.