Version 1.1, 08/2013. Copyright 2012 Hitron Technologies
23
Version 1.1, 08/2013. Copyright 2013 Hitron Technologies
23
Hitron CGN3 User’s Guide
NOTE: This example uses Windows XP; the procedure for your operating system
may be different.
1 Click Start, then click Control Panel.
2 In the window that displays, double-click Network Connections.
3 Right-click your network connection (usually Local Area Connection) and click
Properties.
4 In the General tab’s This connection uses the following items list, scroll
down and select Internet Protocol (TCP/IP). Click Properties.
5 You can get an IP address automatically, or specify one manually:
If your CGN3’s DHCP server is active, select Get an IP address
automatically.
If your CGN3’s DHCP server is active, select Use the following IP address.
In the IP address field, enter a value between 192.168.0.2 and
192.168.0.254 (default). In the Subnet mask field, enter 255.255.255.0
(default).
NOTE: If your CGN3 is not using the default IP address, enter an IP address and
subnet mask that places your computer in the same subnet as the CGN3.
6 Click OK. The Internet Protocol (TCP/IP) window closes. In the Local Area
Connection Properties window, click OK.
Your computer now obtains an IP address from the CGN3, or uses the IP address
that you specified, and can communicate with the CGN3.
1.5 Login to the CGN3
Take the following steps to login to the CGN3’s GUI.
NOTE: You can login to the CGN3’s GUI via the wireless interface. However, it is
strongly recommended that you configure the CGN3 via a wired connection
on the LAN.
1 Open a browser window.
To Next Page
Loading...
Need help?
General
