Version 1.1, 08/2013. Copyright 2012 Hitron Technologies
97
Version 1.1, 08/2013. Copyright 2013 Hitron Technologies
97
Hitron CGN3 User’s Guide
7.4 The Device Filter Screen
Use this screen to configure Media Access Control (MAC) address filtering on the
LAN, and to configure IP filtering.
NOTE: To configure MAC address filtering on the wireless network, see Access
Control Screen on page 78.
You can set the CGN3 to allow only certain devices to access the CGN3 and the
network, or to deny certain devices access.
You can turn filtering on or off, and configure new and existing filtering rules.
Click Security > Device Filter. The following screen displays.
Figure 41: The Security: Device Filter Screen
The following table describes the labels in this screen.
Apply Click this to save your changes to the fields in this
screen.
Close Click this to return to the Service Filter screen without
saving your changes to the trust PC list.
Table 38: The Security: Device Filter Screen
Connected Devices
Host Name This displays the name of each network device
connected on the LAN.
To Next Page
Loading...
