Version 1.1, 08/2013. Copyright 2012 Hitron Technologies
78
Version 1.1, 08/2013. Copyright 2013 Hitron Technologies
78
Hitron CGN3 User’s Guide
5.4 Access Control Screen
Use this screen to configure Media Access Control (MAC) address filtering on the
wireless network.
NOTE: To configure MAC address filtering on the wired LAN, see The Device Filter
Screen on page 97.
You can set the CGN3 to allow only certain devices to access the CGN3 and the
network wirelessly, or to deny certain devices access.
Click Wireless > Access Control. The following screen displays.
Figure 29: The Wireless: Wireless Access Control Screen
Pass Phrase Enter the security key or password that you want to use
for your wireless network. You will need to enter this key
into your wireless clients in order to allow them to
connect to the network.
Save Changes Click this to save your changes to the fields in this
screen.
Cancel Click this to return the fields in this screen to their last-
saved values without saving your changes.
Help Click this to see information about the fields in this
screen.
Table 26: The Wireless: WPS & Security Screen (continued)
To Next Page
Loading...
Need help?
General
