Version 1.1, 08/2013. Copyright 2012 Hitron Technologies
77
Version 1.1, 08/2013. Copyright 2013 Hitron Technologies
77
Hitron CGN3 User’s Guide
Security Mode Select the type of security that you want to use.
Select Open to use no security. Anyone in the
coverage area can enter your network.
Select WEP to use the Wired Equivalent Privacy
security protocol.
Select WPA to use the WiFi Protected Access
(Personal) security protocol.
Select WPA2 to use the WiFi Protected Access 2
(Personal) security protocol.
Select WPA/WPA2 to use both the WPA and the
WPA2 security protocols; clients that support WPA2
connect using this protocol, whereas those that
support only WPA connect using this protocol.
NOTE: Due to inherent security vulnerabilities, it is
suggested that you use WEP only if it is the only
security protocol your wireless clients support.
Under almost all circumstances, you should use
one of the WPA options.
Encrypt Mode Select the type of encryption you want to use. The
options that display depend on the Security Mode you
selected.
WEP:
Select WEP64 to use a ten-digit security key.
Select WEP128 to use a twenty-six-digit security
key.
WPA, WPA2 and WPA/WPA2:
Select TKIP to use the Temporal Key Integrity
Protocol.
Select AES to use the Advanced Encryption
Standard.
Select TKIP/AES to allow clients using either
encryption type to connect to the CGN3.
Table 26: The Wireless: WPS & Security Screen (continued)
To Next Page
Loading...
Need help?
General
