Version 1.1, 08/2013. Copyright 2012 Hitron Technologies
83
Version 1.1, 08/2013. Copyright 2013 Hitron Technologies
83
Hitron CGN3 User’s Guide
6.3 Diagnostics Screen
Use this screen to perform ping and traceroute tests on IP addresses or URLs.
Click Admin > Diagnostics. The following screen displays.
Figure 32: The Admin: Diagnostics Screen
The following table describes the labels in this screen.
Idle Time Use this to set your CGN3’s idle time
Save Changes Click this to save your changes to the fields in this
screen.
Cancel Click this to return the fields in this screen to their last-
saved values without saving your changes.
Help Click this to see information about the fields in this
screen.
Table 30: The Admin: Diagnostics Screen
Destination (IP or
Domain)
Enter the IP address or URL that you want to test.
Ping Select the type of test that you want to run on the
Destination that you specified.
Traceroute
Result This field displays a report of the test most recently
performed.
Apply Click this to save your changes to the fields in this
screen.
Cancel Click this to return the fields in this screen to their last-
saved values without saving your changes.
Help Click this to see information about the fields in this
screen.
Table 29: The Admin: Management Screen (continued)
To Next Page
Loading...
Need help?
General
