Hitron CGNV2 - Resetting the CGNV2; FIGURE 5: GUI Overview; TABLE 3: GUI Overview

23
HITRON CGNV2 USER’S GUIDE
INTRODUCTION
FIGURE 5: GUI Overview
1.7 RESETTING THE CGNV2
When you reset the CGNV2 to its factory defaults, all user-configured settings are
lost, and the CGNV2 is returned to its initial configuration state.
There are two ways to reset the CGNV2:
Press the RESET button on the CGNV2, and hold it in for ten seconds or longer.
Click WAN/LAN > Backup. In the screen that displays, click the Factory Reset
button.
TABLE 3: GUI Overview
Primary
Navigation Bar
Use this section to move from one part of the GUI to another.
Secondary
Navigation Bar
Use this section to move from one related screen to another.
Main Window Use this section to read information about your CGNV2’s
configuration, and make configuration changes.