91
HITRON CGNV2 USER’S GUIDE
WIRELESS
6.4.5 THE CONNECTION LIST SCREEN
Use this screen to view information about the wireless clients connected to the
CGNV2.
Click Wireless > Connection List. The following screen displays.
FIGURE 32: The Wireless > Connection List Screen
Nt This field displays whether the network is using
infrastructure mode, or ad-hoc mode.
NOTE: In infrastructure mode, wireless devices connect
to a central Access Point (AP), which usually
connects to the Internet or another network via a
wired connection. In ad-hoc mode, wireless
devices connect to one another, as peers.
WPS DPID This field displays whether the target network is using
WiFi Protected Setup (WPS) or not. If the target network
is using WPS, this field displays whether it is using PIN
mode, or Push-Button Configuration (PBC) mode.
If the target network is not using WPS, NO displays.
If the target network is using WPS, and allows
wireless devices to connect using the PIN mode, PIN
displays.
If the target network is using WPS, and allows
wireless devices to connect using the push-button
mode, PBC displays.
NOTE: See WPS on page 79 for more information on
WPS, and the difference between PIN and PBC
modes.
TABLE 29: The Wireless > WiFi Site Survey Screen (continued)
To Next Page
Loading...
Need help?
General