42
Lubrication
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
8.6.1 Recommended lubricants
Examples of applications and suitable lubricants are given in the table below.
Damage caused by using the wrong greases!
Greases with solid particles such as graphite or MOS
2
can cause damage.
X Do not use any grease containing solid particles such as graphite or MoS
2
!
ATTENTION!
The information on lubricants serves to provide examples and is only intended as an aid to selection. Other
lubricants may be selected after clarification of the specific application with the lubricant supplier. In addition,
the lubrication system manufacturers’ instructions must be observed.
Type of
application
Grease Low-viscosity grease Oil
Manufacturer Name Manufacturer Name Manufacturer Name
Standard HIWIN G05 Klüber Lubrica-
tion München
MICROLUBE
GB 00
Klüber Lubrica-
tion München
Klüberoil
GEM 1-150 N
Klüber Lubrica-
tion München
MICROLUBE
GL 261
Mobil Mobilux EP 004 FUCHS GEARMASTER
CLP 320
Mobil Mobilux EP 1 FUCHS GEARMASTER
LI 400
FUCHS RENOLIN
CLP 150
FUCHS LAGERMEISTER
BF 2
FUCHS RENOLIT EPLITH
00
— —
LUBCON Turmogrease
CAK 2502
— — — —
FUCHS RENOLIT LZR 2 H — — — —
Klüber Lubrica-
tion München
1)
ISOFLEX TOPAS
AK 50
1)
— — — —
Heavy-duty HIWIN G01 We recommend that you consult a lubricant manufacturer regarding
the use of these lubricants for heavy-duty applications.
Klüber Lubrica-
tion München
Klüberlub
BE 71-501
FUCHS LAGERMEISTER
EP 2
LUBCON TURMOGREASE
Li 802 EP
FUCHS RENOLIT LZR 2 H
Clean room HIWIN G02 We recommend that you consult a
lubricant manufacturer regarding
the use of these lubricants for
heavy-duty applications.
Klüber Lubrica-
tion München
Klüber Tyreno
Fluid E-95V
Klüber Lubrica-
tion München
ISOFLEX TOPAS
NCA 152
Mobil Mobilgear 626
FUCHS GLEITMO 591 FUCHS RENOLIN
CLP 100
Clean room
at high
speeds
HIWIN G03 — — — —
Klüber Lubrica-
tion München
ISOFLEX TOPAS
NCA 52
— — — —
Table 8.3 Recommended lubricants – grease, low-viscosity grease and oil
1)
Recommended for the MG series.
To Next Page
Loading...