General information
5
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
1.2 Depictions used in these assembly instructions
1.2.1 Instructions
Instructions are indicated by triangular bullet points in the order in which they are to be carried out.
Results of the actions carried out are indicated by ticks.
Example:
X Place an eligible press-in block upright on the cap.
X With a plastic hammer hit in the bolt cap through a central blow to the press-in block.
X With plastic bolt caps a burr may form during pressing in.
X Remove this burr.
Bolt cap has now been mounted.
1.2.2 Lists
Lists are indicated by bullet points.
Example:
Lubricants
| reduce wear
| protect against dirt
| …
1.2.3 Depiction of safety notices
Safety notices are always indicated using a signal word and sometimes also a symbol for the specific risk (see Section 1.2.4).
The following signal words and risk levels are used:
Imminent danger!
Noncompliance with the safety notices will result in serious injury or death!
X Follow the safety instructions!
DANGER!
Potentially dangerous situation!
Noncompliance with the safety notices runs the risk of serious injury or death!
X Follow the safety instructions!
WARNING!
Potentially dangerous situation!
Noncompliance with the safety notices runs the risk of slight to moderate injury!
X Follow the safety instructions!
CAUTION!
Potentially dangerous situation!
Noncompliance with the safety notices runs the risk of damage to property or environmental pollution!
X Follow the safety instructions!
ATTENTION!
To Next Page
Loading...
Need help?
General
