Hiwin MG Series - Procedure for Incidents

52
Procedure for incidents
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
Interference Possible cause Remedy
High level of operating noise
while the linear guideway is
running
Travel speed of the linear guideway is
too high
Check the permissible travel speed (see
Section 12.1)
Insufficient lubrication Lubricate the linear guideway as speci-
fied in the lubrication instructions
Blocks require high displace-
ment forces
Preload of the block on the rail is too
high
Check the required preload of the block
Insufficient lubrication Lubricate the linear guideway as speci-
fied by the lubrication instructions
Block is losing balls The block is damaged or the seals on the
block are damaged.
Contact the HIWIN support.
10.
Procedure for incidents