Hiwin MG Series - Accessories; Self-lubricating Block

Accessories
53
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
11. Accessories
11.1 Self-lubricating block
Pos. Name
1 Oil tank
2 Connection piece
3 End seal
4 Deflection system
5 Lubrication unit
6 Fixing screws
X If necessary disassemble the existing grease nipple and the end seal(s).
X Place the lubricating unit [5] on the block.
X Place the end seal(s) [3] in front of the lubricating unit [5].
X Tighten the fixing screws [6].
X Mount the connection piece [2].
X Push the oil tank [1] on to the lubricating unit until you hear a click.
 The self-lubricating E2 block has been mounted.
The screw size and the size of the connection piece can vary depending on which type of dust protection is used.
NOTE
Fig. 11.1 Exploded view of self-lubricating E2 block for the HG, EG and RG series
Table 11.1 Key for Fig. 11.1
11.1.1 Self-lubricating E2 block for the HG, EG and RG series
The self-lubricating E2 block consists of a lubricating unit [5] located between the deflection system [4] and the end seal
[3], s connection piece [2], and an interchangeable oil tank [1]. Lubricant from the oil tank passes via the connection piece
to the lubrication unit, from where the lubricant is transferred to the track of the profile rail.
11.1.1.1 Assembly
[5]
[3] [4][1]
[6]
[2]