Hiwin MG Series - Page 54

54
Procedure for incidents
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
Pos. Name
1 End seal
2 Lubrication unit with oil tank
3 Fixing screws
X If necessary disassemble the existing grease nipple and the end seal(s).
X Place the lubricating unit [2] on the block.
X Place the end seal(s) [1] in front of the lubricating unit [2].
X Tighten the fixing screws [3].
 The self-lubricating E2 block has been mounted.
The screw size and the size of the connection piece can vary depending on which type of dust protection is used.
NOTE
Fig. 11.2 Exploded view of self-lubricating E2 block for the CG series
Table 11.2 Key for Fig. 11.2
11.1.2 Self-lubricating E2 block for the CG series
The self-lubricating E2 block for the CG series consists of a lubrication unit with oil tank [2] and an additional end seal [1].
The ball bearing track is lubricated via the lubrication unit.
11.1.2.1 Assembly
[3]
[2][1]