Hiwin MG Series - Page 55

Procedure for incidents
55
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
Standard oil:
Mobil SHC 636
Fully synthetic with a hydrocarbon base (PAO)
Viscosity grade: ISO VG 680
Alternatively, oils of the same classification and viscosity may be used.
Model Oil quantity [cm
3
] Mileage [km]
HG15E2 1.6 2,000
HG20E2 3.9 4,000
HG25E2 5.1 6,000
HG30E2 7.8 8,000
HG35E2 9.8 10,000
HG45E2 18.5 20,000
HG55E2 25.9 30,000
HG65E2 50.8 40,000
EG15E2 1.7 2,000
EG20E2 2.9 3,000
EG25E2 4.8 5,000
EG30E2 8.9 9,000
RG25E2 5.0 6,000
RG30E2 7.5 8,000
RG35E2 10.7 10,000
RG45E2 18.5 20,000
RG55E2 26.5 30,000
RG65E2 50.5 40,000
Table 11.3 Oil quantities in the oil tank
The replacement intervals of the oil tank depend greatly on the loads and the environmental conditions. Environ-
mental influences such as high loads, vibrations and dirt shorten the replacement intervals.
NOTE
11.1.3 Replacement intervals
You can either fill the oil tank using an injector via the fill holes on the side or you can replace the whole compo-
nent.
NOTE
Table 11.3 indicates the maximum interval at which the fill level of the oil tank should be checked.
NOTE