Hiwin MG Series - Warranty and Liability; Manufacturers Details; Copyright; Product Monitoring

6
General information
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
1.2.4 Symbols used
The following symbols are used in these assembly instructions:
Table 1.2 Warning signs
1.2.5 Information
Warning of dangerous electrical voltage!
Substance hazardous to the environ-
ment!
Warning of crushing!
Warning of danger from suspended
loads!
1.3 Warranty and liability
The manufacturer’s “General conditions of sale and delivery” apply.
1.4 Manufacturer’s details
Address HIWIN GmbH
Brücklesbünd 1
D-77654 Offenburg, Germany
Phone +49 (0) 781 / 9 32 78 - 0
Technical customer service +49 (0) 781 / 9 32 78 - 77
Fax +49 (0) 781 / 9 32 78 - 90
Technical customer service fax +49 (0) 781 / 9 32 78 - 97
E-mail support@hiwin.de
Website www.hiwin.de
Table 1.3 Manufacturer’s details
1.5 Copyright
These assembly instructions are protected by copyright. Any reproduction, publication in whole or in part, modification or
abridgement requires the written approval of HIWIN GmbH.
1.6 Product monitoring
Please inform HIWIN, the manufacturer of the linear guideways of:
| Accidents
| Potential sources of danger in the linear guideways
| Anything in these assembly instructions which is difficult to understand
Describes general information and recommendations.
NOTE
Warning of danger of cuts!