HOMEGRID Stack'd Series - Set Up Wi-Fi Through the App; Confirming Network Connectivity

24 25
INSTALL
INSTALL MANUAL
Once installers have completed seng up network parameters,
they can verify that the system is connected to the local Wi-
 network and is communicang with HomeGrid servers by
observing the following:
On Gen 2 systems using a Skybox interface, noce a green light
indicator.
• A steady green indicator means it is connected to the local
Wi-Fi network.
• A blinking green indicator means it is connected to the
HomeGrid server.
On Gen 3 Systems, temporarily change ‘Invert Set’ DIP switches
on the BMS to the following:
• (#1,2 DOWN, #3,4,5,6 UP)
• Observe the display on BMS for a code 60 followed by
either a 0, 1, or 2
- 0 Indicates no connecon to Wi-Fi.
- 1 indicates a connecon to local Wi-Fi.
- 2 indicates a connecon to Wi-Fi and HomeGrid
server.
• Return the ‘Invert Set’ DIP switches to their previous
sengs.
Please contact HomeGrid Support at 725-373-5350 or email
support@lithionbaery.com for assistance.
Conrming Network Connecvity
Once installers have met all the requirements, they must follow
the setup prompts provided upon selecng the ‘Network’
opon within the HomeGrid App. They will be given visual
cues for the process and will be redirected to their monitoring
device’s Wi-Fi sengs. You will need to rst link to the local
hotspot created by the Skybox or Gen 3 BMS. The name of this
hotspot will look like the serial number for the device
(Skybox or BMS). Installers then connect to the hotspot and
enter 12345678 for its password. Conrm your monitoring
device has connected to the hotspot and then return to the
app. You should be able to resume from where you last le o,
if necessary, press the back buon and reengage the setup
process.
• iOS users, enter SSID (local Wi-Fi Network name) exactly
as detected, along with the password. If successful, you will
get a ‘Command sent succeeded’ message.
• Android users, select the local Wi-Fi Network and enter
the password. If successful, you will get a ‘Command sent
succeeded’ message.
Once installers have completed entering the Wi-Fi Network
parameters, they should close the HomeGrid Energy app,
reconnect to the local Wi-Fi network or mobile data network
and reopen the app. Upon opening the app, they may need to
refresh the app by pulling down on the home screen with your
nger to refresh the app. You will noce at the top, the date and
me the app was last refreshed.
Users may be required to refresh the app every me they close
and open the app. The app does not automacally refresh. For
updated informaon, refresh as needed.
Set Up Wi-Fi Through the App