140
MAINTENANCE
9. Connect the water level sensor 2
pin connector. Install the harness to
the clip C and harness clip.
Align the positioning bands on the
harness with the end of the clip C
and harness clip as shown above.
10. Reinstall the water separator in
the reverse order of removal.
11. Prime the engine using the
priming bulb (p.72). Check for
fuel leaks.
Repair any fuel leaks if necessary.
If the buzzer sounds, water or
sediment accumulation is found to be
caused by excessive water or
sediment accumulated in the water
separator cup, inspect the fuel tank.
Clean the fuel tank if necessary.
POSITIONING
BAND
HARNESS CLIP
WATER LEVEL
SENSOR 2 PIN
CONNECTOR
CLIP C
POSITIONING
BAND
<;DQQMࡍࠫ㧞㧜㧝㧟ᐕ㧝㧜㧝㧤ᣣޓ㊄ᦐᣣޓඦᓟ㧞ᤨ㧟㧟ಽ
To Next Page
Loading...
