Honda BF75D - Starting Procedure (R Type)

76
STARTING THE ENGINE
6. Check to see if the oil pressure
indicator light turns ON.
If it does not turn on, stop the
engine and perform the following
inspections.
1)Check the oil level (see page 59).
2)If the oil level is normal and the
oil pressure indicator light does
not turn ON, consult with an
authorized Honda outboard
motor dealer.
7. Warm up the engine as follows:
Above 5°C (41°F)
– run the engine
for at least 3 minutes.
Below 5°C (41°F)
– run the engine
for at least 5 minutes at approx.
2,000 min
-1
(rpm).
Failure to completely warm up the
engine will result in poor engine
performance.
If the engine is not properly
warmed-up before raising the
engine speed, the warning buzzer
and overheat indicator may 
activate and the engine speed will
be automatically reduced.
Before leaving the dock, check the
operation of the emergency stop
switch.
Starting the Engine (R type)
The exhaust contains poisonous
carbon monoxide.
Do not start the engine in a poor
ventilation area such as in a boat
house.
To prevent damage to the outboard
from overheating, never run the
engine with the propeller out of
water.
NORMAL: ON
ABNORMAL: OFF
ENGINE OIL
PRESSURE
INDICATOR
LIGHT
(R1 type)
EMERGENCY STOP
SWITCH
EMERGENCY STOP
SWITCH CLIP
EMERGENCY
STOP SWITCH
LANYARD
STOP
<;DQQMࡍ࡯ࠫ㧞㧜㧝㧟ᐕ㧝㧜᦬㧝㧤ᣣޓ㊄ᦐᣣޓඦᓟ㧞ᤨ㧟㧟ಽ