25
SERVICING YOUR TILLER
HONDA FC600 (E) xxxxxxxxxxxx -25-
MAINTENANCE SCHEDULE
(1) Service every 10 operation hours or every day when used in dusty areas.
(2) These items should be serviced by your servicing dealer, unless you
have the proper tools and are mechanically proficient. Refer to Honda
shop manual for service procedures.
See “Honda Publications” on page 57 for ordering information.
(3) For commercial use, log hours of operation to determine proper
maintenance intervals.
(4) Check that there are no cracks or abnormal wear in the belt, and replace
it if necessary.
Failure to follow this maintenance schedule could result in non-warrantable
failures.
REGULAR SERVICE PERIOD (3)
After
storage
Each
use
First
month
or
20 hrs.
Every
3
months
or
50 hrs.
Every
6
months
or
100 hrs.
Every
year
or
300 hrs.
Page
Item Perform at every indicated
month or operating hour
interval, whichever comes first.
Engine oil Check level { 28
Change {{{29
Transmission oil Check level {{ 31
Air filter Check {
32, 33Clean {(1)
Replace {
Tiller outside Check {
-
Clutch lever function Check {
-
Bolts and Nuts tighten Check-
tightness
{
-
Wiring and cables Check {
-
Engine operation Check { 15
Sediment cup Clean { 39
Spark plug Check-adjust {
34, 35
Replace {
Spark arrester
(Optional parts)
Clean
{ 40
Belt tension Adjust {(4) {(4) 37, 38
Throttle cable Adjust {{36
Clutch cable Adjust {(2) 36
Idle speed Check-adjust {(2)
-
Valve clearance Check-adjust {(2)
-
Combustion chamber Clean Aftar every 500 hrs. (2)
-
Fuel tank and filter Clean {(2) {(2)
-
Fuel tube Check Every 2 years (Replace if necessary)(2)
-
FC600_06_EN.fm 25 ページ ２０１２年４月２３日 月曜日 午後４時５２分
To Next Page
Loading...
