47
HONDA FC600 (E) xxxxxxxxxxxx -47-
TRANSPORTING
BEFORE LOADING
If the engine has been running, allow it to cool for at least 15 minutes before
loading the tiller on the transport vehicle. A hot engine and exhaust system
can burn you and can ignite some materials.
Always turn the ignition switch to the OFF position. Make sure to turn the fuel
valve OFF.
LOADING AND UNLOADING
If a suitable loading ramp is not available, two people should lift the tiller on
and off the transport vehicle while holding the tiller level.
Position the tiller so it sits flat on the bed of the transport vehicle. Tie the tiller
down with rope or straps. Keep the tie-down rope or straps away from the
controls, adjustment levers, cables, and the carburetor.
00X31-733-7200_FC600_EN.book 47 ページ ２０１２年４月２０日 金曜日 午後８時５分
To Next Page
Loading...
