Honda Modular Vehicle Communication Interface - USB Device

4. To save your changes, scroll down to the Network Service option, then press ENTER.
USB Device
1. To change the USB device network settings, select USB Device under Network Setup, then press ENTER.
2. To change the IP address, highlight the IP address, then press ENTER. Use the up/down buttons to change the
number and the left/right buttons to move between the components of the IP address.
Press ENTER to accept the changes, then press ESC to return to the previous menu. To return to the previous
menu without accepting the changes, press ESC.
3. To change the subnet mask, highlight the Subnet Mask, then press ENTER. Use the up/down buttons to change
the number and the left/right buttons to move between the components of the Subnet Mask.
Press ENTER to accept the changes, then press ESC to return to the previous menu. To return to the previous
menu without accepting the changes, press ESC.
4. To save your changes, scroll down to the Network Service option, then press ENTER.
28