FRONT WHEEL/SUSPENSION/STEERING
THROTTLE HOUSING
DISASSEMBLY
Remove the following:
- three screws
- throttle housing cover
- gasket
BOOT
Slide the boot off the throttle cable adjuster.
Loosen the lock nut and cable adjuster.
Bend down the lock washer tab and remove the fol-
lowing:
- pivot nut and lock washer
- throttle lever and washer
- return spring
- throttle arm (by disconnecting the throttle cable)
- dust seal (from the housing bottom)
ASSEMBLY
Coat a new dust seal lip with grease and install it
into the throttle housing until it is fully seated.
WASHER
Apply grease to the throttle lever pivot in the hous-
ing and to the throttle cable end.
Connect the cable to the throttle arm.
Install the washer onto the throttle lever and insert
the throttle lever into the throttle housing.
Install the throttle arm with the spring over the lever
pivot by aligning the flat surfaces as shown.
Install a new lock washer and the pivot nut, and
tighten it. Bend up the washer tab against the nut.
15-10
To Next Page
Loading...
