Honeywell 4850DR - Page 129

9 - 10
Data Formatter Selections
Data Format Editor *Default Data Format (None) DFMDF3 5-1
Enter Data Format DFMBK3## 5-2
Clear One Data Format DFMCL3 5-2
Clear All Data Formats DFMCA3 5-2
Data Formatter Data Formatter Off DFM_EN0 5-10
*Data Formatter On,
Not Required,
Keep Prefix/Suffix
DFM_EN1 5-11
Data Format Required,
Keep Prefix/Suffix
DFM_EN2 5-11
Data Formatter On,
Not Required,
Drop Prefix/Suffix
DFM_EN3 5-11
Data Format Required,
Drop Prefix/Suffix
DFM_EN4 5-11
Data Format Non-Match Error Tone *Data Format Non-Match Error
Tone On
DFMDEC0 5-11
Data Format Non-Match Error
Tone Off
DFMDEC1 5-11
Primary/Alternate Data Formats Primary Data Format ALTFNM0 5-12
Data Format 1 ALTFNM1 5-12
Data Format 2 ALTFNM2 5-12
Data Format 3 ALTFNM3 5-12
Single Scan Data Format Change Single Scan-Primary
Data Format
VSAF_0 5-12
Single Scan-Data Format 1 VSAF_1 5-12
Single Scan-Data Format 2 VSAF_2 5-12
Single Scan-Data Format 3 VSAF_3 5-12
Symbologies
All Symbologies *All Symbologies Off ALLENA0 6-1
All Symbologies On ALLENA1 6-1
Codabar Default All Codabar
Settings
CBRDFT 6-2
Off CBRENA0 6-2
*On CBRENA1 6-2
Codabar Start/Stop Char. *Don’t Transmit CBRSSX0 6-2
Transmit CBRSSX1 6-2
Codabar Check Char. *No Check Char. CBRCK20 6-2
Validate, But Don’t Transmit CBRCK21 6-2
Validate, and Transmit CBRCK22 6-2
Codabar Concatenation *Off CBRCCT0 6-3
On CBRCCT1 6-3
Require CBRCCT2 6-3
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page