Configuring Video Analytics
63
Figure 7-7 Action
Trigger digital input for x seconds: Select this option to trigger alarm output for x seconds.
Enter a value in the textbox.
Backup media if the network is disconnected:
Select this option to backup media files to SD card if the network is disconnected. This
function will apply after you configure the Email and HTTP. For example, if a snapshot is
supposed to be delivered to an Email receiver, in the event of network failure, the snapshot will
be saved in the SD card.
Trigger auto tracking: Select this option to trigger auto tracking. This function is applicable to
HC60WZ2E30.
Move to preset location: Select this option to trigger the camera to preset location. Select a
preset location from the dropdown list. You should configure preset locations first, see Adding
a Preset Patrol on page 39. This function is applicable to HC60WZ2E30.
SD Test: Click to test your SD card. The system will display a message indicating the result as
a success or a failure. If you want to use your SD card for local storage, format it before use.
For more information, see SD Card Format on page 70 .
Add Server
Note
Before adding server or adding media, click SAVE EVENT to avoid
that the event will be lost when adding server or adding media.
Click Add server to open the server setting window. You can specify where the notification
messages are sent to when a trigger is activated. A total of 5 server settings can be
configured.
There are the following server types available: Email and HTTP. Select the item to display the
detailed configuration options. You can configure either one or all of them.
To Next Page
Loading...
Need help?
General
