CHAPTER
1
Introduction
Learn what you need to know about the Honeywell BW™ Icon Gas Detector before operating.
Product Description
The Honeywell BW™ Icon & Honeywell BW™ Icon+ gas detectors warns of hazardous gas at levels
above user-defined alarm setpoints. The detector can monitor up to four gases at a time.
Safety
CAUTION
• The detector is a personal safety device. It is your responsibility to respond properly to
the alarm.
• For safety reasons, this equipment must be operated and serviced by qualified personnel only.
• The lithium battery in this product presents a risk of fire, explosion, and chemical burn if
misused. Do not disassemble, incinerate, or heat above 212°F (100°C). Batteries exposed to heat
at 266°F (130°C) for 10 minutes can cause fire and explosion. Batteries must only be charged in a
safe area free of hazardous gas.
• Deactivating the detector by removing the battery pack may cause improper operation and harm
the detector.
• Use only Honeywell approved battery chargers such as the vehicle Charger.
• Do not use the apparatus if it is damaged. Inspect the apparatus before use. Look for cracks and
missing parts.
Standards and Certifications
IECEx: IECEx SIR 20.0020X
Ex ia op is I Ma Ex ia op is IIC T4 Ga, -40°C≤ Tamb ≤ 60°C (with IR sensor installed)
Ex ia I Ma Ex ia IIC T4 Ga, -40°C≤ Tamb ≤ 60°C
BW Icon 5 User Manual
www.CanarySense.com
Shop for Gas products online at:
1.888.610.7664
To Next Page
Loading...
