Honeywell Evohome

Install the Radiator Controllers (HR92)
1
Locate the room (zone) for the radiator controller
2
Slide the locking mechanism to the unlock position
3
Remove the adaptor from the bottom of the controller
4
Unscrew the black wheel fully anticlockwise
5
Remove any existing control on the radiator valve
6
Screw the white end of the adaptor on to the radiator valve
7
Push the controller fully on to the adaptor
with the screen facing towards you
8
Slide the locking mechanism to the locked position
REMOVE
ROTATE
2
3
3 4
7
15evohome Installation Guide