Honeywell Evohome

Step 2: Set up your evohome Controller
Power up the evohome Controller and follow the on-screen instructions for your system
Go to Installer Menu Go to Guided Configuration Go to Home screen
You have…
a Base Pack or a
Connected Pack
+
Un-bound devices
You have…
an un-bound evohome
Controller
+
Un-bound devices
You have…
a Base Pack or a
Connected Pack
+
No additional devices
Step 3: Power up and bind devices
Power up all devices, including the battery powered ones,
and bind them to the evohome Controller
Step 1: Wire up your heating system
Connect all mains powered devices to the heating system
Step 4: Test the system
Check that all the devices are working properly
2 Step 1: Wire up the heating system