Honeywell Evohome

To fit the CS92 Insertion Sensor
1
Fit in the cylinder immersion well with suitable fittings to
provide strain relief and prevent accidental removal
2
If the sensor doesn’t fit tightly in the immersion
well fill the space with heat-conductive compound
to ensure maximum heat transfer
3
Install the CS92 Transceiver in a suitable location close
enough for the cable from the sensor to reach
4
Connect the cable from the sensor to the CS92 Transceiver
4
A x B Cy
A x B Cy
Wire to CS92 Transceiver
Wireless Cylinder Thermostat (CS92) continued
6 Step 1: Wire up the heating system