Wireless Cylinder Thermostat (CS92A)
1
Press the button on the Cylinder Thermostat transceiver
2
The green light should come on. If it doesn’t,
reinsert the batteries and try again
The evohome Controller will display the signal strength
(poor to excellent) and the transceiver should flash
the red LED from 1 flash (poor) to 5 flashes (excellent)
– no flashing means the transceiver has not received
a test signal from the evohome Controller.
To exit test mode press the button on the transceiver.
1
PRESS FOR
5 SECONDS
35evohome Installation Guide
To Next Page
Loading...
