Honeywell Evohome

Battery Powered Wireless Devices
Battery powered devices need to be put into
test mode to send and receive a test signal:
Radiator Controller (HR92)
1
Press the button, the zone name is displayed
2
Press and hold the button again for 5 seconds
3
Turn the dial to display RF CHECK
4
Press the button
The evohome Controller will display the signal strength
(poor to excellent) and the Radiator Controller will display
a signal strength bar and a rating from 1 (poor) to 5
(excellent) – 0 means the Radiator Controller has not
received a test signal from the evohome Controller.
5
To exit test mode turn the dial to exit and press the
button. It will exit automatically after 10 minutes.
1 2 3 4
31evohome Installation Guide