Room Temperature Sensor (HCF82 or HCW82)
1
Remove the cover from the sensor
2
Press and hold the bind button until the red
LED goes off (approx 30 seconds)
3
The red LED will flash each time it sends a test message
The evohome Controller will display the signal strength (poor
to excellent) – no flashing means the Temperature Sensor has
not received a test signal from the evohome Controller.
4
To exit test mode, press the bind button on the Temperature
Sensor. It will exit automatically after 5 minutes.
1 2
PRESS FOR
30 SECONDS
Advanced RF communication check continued
34 Step 4: System test
To Next Page
Loading...
