Honeywell Evohome

To bind the Wireless Relay Box (BDR91)
controlling the hot water valve
1
On the Wireless Relay Box, press and hold the
button for 15 seconds (until the red LED blinks
rapidly) to clear any previous binding data
2
Press and hold the button again for 5 seconds
(until the red LED blinks slowly)
3
On the evohome Controller press
the green bind button
4
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
You may need to refer to
the wiring diagrams in
the Appendix
!
HOLD
15 SEC
HOLD
5 SEC
1 2
17evohome Installation Guide