Honeywell Evohome

To bind the Room Temperature
Sensor (HCW82 or HCF82)
1
Press the bind button on the bottom right hand corner
of the unit once. The red LED light will flash
2
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
Then on the Mixing Valve Controller
1
Press and hold both buttons on the Mixing Valve
Controller for 4 seconds until the red light flashes
2
On the evohome Controller press
the green bind button
3
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
1
PRESS
AND HOLD
4 SEC
1
28 Step 3: Power up and bind devices