Application description
The HCE80(R) / HCC80(R) underoor heating controllers individually control up to 8 zones. For zone 1, the internal room
sensor from the evotouch controller is used. All other zones (2 – 6) require their own HCF82 room sensor to measure
the room temperature.
The HCF82 directly communicates with the evotouch controller in order to send the room temperature. The room
temperature setpoints change according to the time program. The manual setpoint override is only possible with the
evotouch controller.
The underoor heating controllers HCE80(R) / HCC80(R) communicate directly only with the evotouch controller and
receive the room temperature and room temperature setpoint for each zone individually.
In total, 8 zones can be controlled individually.
Options
Heat demand
The evotouch controller calculates the heat demand and communicates it to the boiler relay BDR91 / HC60NG or
OPENTHERM-Bridge which controls the boiler.
Outdoor sensor
The HB85 outdoor sensor measures the outside temperature. It must be installed if data is required.
Steps to do
Activate the internal room sensor of the f evotouch controller for zone 1. See section 4.2
Bind the f evotouch controller to the HCF82 room sensor individually for each zone 2 – 6. See section 4.9
Bind the sensor information from the f evotouch controller to the underoor heating controller
individually for each zone 1 – 6. See section 4.7.1
Bind the setpoint information from the f evotouch controller to the underoor heating controller
individually for each zone 1 – 6 See section 4.7.2
Optional: Bind the f evotouch controller to the BDR91 / HC60NG relay module
for boiler feedback. See section 4.5
Optional: Bind the f evotouch controller to the HB85 sensor for outdoor temperature. See section 4.10
Check RF communication for each sensor and actuator individually. f
To Next Page
Loading...
